Xicoolee feature image

Xicoolee

Review rating Review rating Review rating Review rating Review rating 4.3

* We independently evaluate all recommended products and services. If you click on links we provide, we may receive compensation.

Products of the Xicoolee range from £16.08 to £33.68, and the average price of all the products is about £22.67. So your total expense can vary depending on the products chosen, which allows you to choose products according to your budget.

Xicoolee has a relatively small number of products for sale, only 21. We analyzed some of them in detail and recommended them to our readers. The Xicoolee review will examine the core factors of the brand and its products to help you make an informative buying decision.

Xicoolee Best Sellers

Last Updated: 16 Jun 2023

XICOOLEE 5PCS 4Pin Dupont Line PH2.0mm Pitch, Grove - Universal 4 Pin Buckled 25cm Cable (5 PCs Pack)

1.Converts Grove Connector to Grove Connecter
2.Supports Raspberry Pi and Arduino
3.5 Pieces per Pack
4.25cm with Buckled Grove Connector
5.PH2.0mm Pitch

XICOOLEE CAN HAT Communication Module, Single Channel CAN Bus Transceiver Adopting SN65HVD230 Electric Circuit

Low current standby mode, typical current is 370μA
The module is fully compatible with the ISO11898 standard. High input impedance, allowing 120 nodes
With the anti-instantaneous interference and protecting the bus function
Slope control,and reduce radio frequency interference (RFI); differential receiver with anti - wide range of common - mode interference and electromagnetic interference ( EMI ) capacity
Signal transmission rate up to 1Mb/s, with thermal protection, open circuit failure protection function

XICOOLEE 2pcs MG-90S Servo Micro 12g Servo Motor Metal Gear Digital Servo for RC Airplane Model Car Helicopter Robot Diving Equipment Racing Model

1.Strong compatibility, whether it is the program or mechanical structure for lego-build, as far as possible compatible processing;
2.12g Servo, control is simple, accurate angle and fast response;
3.Suitable for RC helicopters, aircraft, ships, vehicles, etc., and various angle control models;
4.Metal Servo motor with higher torque and quality.
5.3Pin 2.54mm DuPont cable Header; Operating voltage: 4.8V~6.0V

XICOOLEE CAT9555 IO Expansion Module Board I2C Interface , SMBus I/O Port, 16 bit Parallel GPIO Expander, with Pre-soldered Header

400 kHz I2C bus compatible
5V tolerant I/O, high drive capability of I/O ports
Polarity inversion register, active low interrupt output
Low stand−by current
Internal power−on reset

xicoolee 2inch LCD IPS Screen Display Module,Support 262K Colors, 240x320 Resolution internal ST7789V Driver, Adopting 4-wire SPI Interface, LCD Monitor

A internal ST7789V controller in the screen
Small and exquisite size, 240x320 resolution, IPS screen, 262K colors, displaying clearly and colorful
SPI interface and less pins occupancy
Provides open source demo codes for Raspberry Pi
Convenient for users to DIY in various scenarios

XICOOLEE 5PCS 4Pin Dupont Line PH2.0mm Pitch, Grove - Universal 4 Pin Buckled 50cm Cable (5 PCs Pack)

1.Converts Grove Connector to Grove Connecter
2.Supports Raspberry Pi and Arduino
3.5 Pieces per Pack
4.50cm with Buckled Grove Connector
5.PH2.0mm Pitch

XICOOLEE Raspberry Pi Pico Board Kit, Dual-Core ARM Cortex M0+ Processor, Based on The Raspberry Pi RP2040 Chip,with Flexible Digital interfaces and Pre-soldered Header(Color-Coded)

Precise clock and timer on-chip, temperature sensor and accelerated floating-point libraries on-chip
A small, fast, and multifuctional microcontroller panel,264KB of SRAM
It adopts dual-core arm Cortex M0+ processor, flexible clock running up to 133 MHz., internal 264KB of SRAM, and 2MB of on-board flash memory.
8 × Programmable I/O (PIO) state machines for custom peripheral support
26 × multi-function GPIO pins,2 × SPI, 2 × I2C, 2 × UART, 3 × 12-bit ADC, 16 × controllable PWM channels

XICOOLEE SG-92R 9G Micro Digital Servo Nylon Carbon Fiber Gears High Precision Gear High Torque Servo for programmable Fixed Wing, Helicopter KT, Intelligent car, Small Robot DC4.8V/6V(2pcs)

1.Strong compatibility, whether it is the program or mechanical structure for standard building blocks, as far as possible compatible processing;
2.It is made of environment-friendly POM plastic, which is small, light and not easy to be damaged;
3.Suitable for fixed wing, helicopter KT, gliding, intelligent car, small robot manipulator and other models;
4.Classic 9g Servo, control is simple, 3Pin 2.54mm DuPont cable Header;
5.Supply Voltage:DC4.8V-6V, Operating speed(at no load): 4.8V 0.12±0.01sec/60°6V 0.1±0.01sec/60°

XICOOLEE Solar Energy/Power Management Module, Solar Power for 5V-24V Solar Panel, Supports Solar Panel or USB Port Battery Charging

Supports solar panel / power adapter/USB multiple methods of connections for battery charging.
Supports MPPT (Maximum Power Point Tracking) function, maximizing the efficiency of the solar panel. On-board MPPT SET switch, select the level closed to input level to improve charging efficiency.
Suitable for 5V-24V solar panel, being wiring through DC-044 power jack or terminal block.
Onboard various status indicators for checking the status of solar panel and battery easily. Multi protection circuits: over charge / over discharge / reverse protection / over current, stable and safe to use.
On-board 18650 battery holder and PH-2P battery socket, convenient to connect multi kinds of 3.7V rechargeable Li battery or Li battery pack.

XICOOLEE Pico Expansion Plus for Raspberry Pi Pico Two Sets of External Expansion Pins 2x20PIN,Pico Dual Expander

2 sets of 2*20 external expansion pins:They are convenient for users to access to the raspberry PI Pico expansion board or dupont wire to peripherals.
26 GPIO Indicators:The GPIO status display function can be turned on by toggling the switch S1 to the ON state. At this time, when the GPIO is at a high level, the corresponding LED indicator light is on, otherwise the light is off. If you do not need to display the GPIO status through the LED status, you can turn the switch S1 to the OFF state.
A group of SPI1 interfaces (pin header form): They can be connected to the SPI peripheral module through flat cables or DuPont cables. The SPI1 interface is consistent with the VCC voltage of the six HY-2.0-4P connectors.
A reset button. This product increases the reset button, so it is convenient for users to debug or write programs without frequent plugging USB line of Pico.
6 HY-2.0-4P interfaces: They can be inserted into 2.0-spaced cables. It is quick and convenient to connect to other functional modules.

XICOOLEE BME280 Environmental Sensor, Temperature Humidity Barometric Pressure Monitoring Module, Support I2C/SPI Interface Compatible with 3.3V and 5V

1. I2C (default) and SPI interfaces can be easy to convert
2. Onboard RT9193-33 LDO Regulator, Ultra-Low-Power, Quick Start-Up
3. Onboard voltage level translator, compatible with 3.3V and 5V
4. Temperature sensing: -40~85°C (resolution 0.01°C, accuracy ±1°C); humidity sensing: 0~100%RH (resolution 0.008%RH, accuracy ±3%RH); barometric Pressure sensing: 300~1100hPa (resolution 0.18Pa, accuracy ±1hPa)
5. Provides open source demo codes available for Raspberry Pi, Ardui. and STM32 development boards

XICOOLEE 1.44inch LCD Display Module for Raspberry Pi Pico, 128×128 Resolution Screen TFT Display Module, 65K RGB, Embedded ST7735S Driver SPI Interface, Compatible with Raspberry Pi Pico Header

1.44 inch LCD display module for Raspberry Pi Pico, 128×128 resolution, 65K RGB colors screen, clear and colorful displaying effect
Embedded ST7735S Driver, SPI interface, requires minimal IO pins
Onboard a joystick and four buttons for easy interacting
Dimensions: 65mm(L)*30.3mm(W), Backlight:LED, Supply Voltage: 3.3V
Provides open source demo codes that can be used with the Raspberry Pi Pico development board

XICOOLEE Programmable Geekservo Compatible with Standard Building Blocks for Ardui Microbit Raspberry Pi,Geekservo Compatible Building Block Gear Motor/Servo 360 Degree(4pcs Red Motor)

1.It is made of environment-friendly POM plastic, which is small, light and not easy to be damaged;
2.Strong compatibility, whether it is the program or mechanical structure for standard building blocks, as far as possible compatible processing;
3.Classic 9g motor, 14g servo ,control is simple;
4.Multiple motors and servos can be used to build blocks, and DIY a variety of shapes;
5.Maximum travel of grey servo is about 270°, red motor is 360°. The gray servo has 3-pin connection cable, red motor is 2-pin. The Operating Voltage of gray servo is 4.8V-6V, red motor is 3V.

xicoolee 2.13inch E-Paper Display Module for Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+, 122 x 250 Pixels Two-Colour, Supports Partial 560ms and Full 950ms Refresh SPI Interface

122 x 250 pixels, 2.13 inch e-paper e-ink display module is based on Raspberry Pi 40PIN GPIO header design, applicable to Raspberry Pi series motherboard, such as Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+/4B
Supports partial refresh minimum 560ms (4-wire SPI status) and full refresh Minimum 950ms (4-wire SPI status). We provide open source demo codes available for Raspberry Pi, Ardui. Mega and STM32 development boards
SPI communication interface is reserved to facilitate connect to Arduino/STM32 and other control boards. SPI interface, less pin occupation. Adds a SPI line number selector switch
Onboard Voltage Translator, which can be compatible with 3.3V and 5V MCUs
Low power consumption. Keeps displaying last content for a long time even when power down. Basically power is only required for refreshing

XICOOLEE MG-996R 55g Servo Metal Gear High Speed Torque Servo Digital Servo Motor for Programmable Biped Robots,Manipulators, Remote Control Boat, Smart Robot, Helicopter,DIY(4pcs)

1.Strong compatibility, whether it is the program or mechanical structure for standard building blocks, as far as possible compatible processing;
2.Stall torque (at locked): 4.8V 11±0.1kg-cm6V 13±0.1kg-cm, Stall current (at locked): 4.8V 2000±30mA 6V 2200±30mA;
3.Operating speed (at no load): 4.8V 0.12±0.01sec/60° 6V 0.11±0.01sec/60°,Running current (at no load): 4.8V 220±20mA 6V 250±20mA;
4.It can be used in aircraft models, remote control, robots and other occasions where the angle needs to be controlled, with large torque and quick response;
5.55g Servo ,control is simple, Supply Voltage:DC4.8V / DC6V, 3Pin 2.54mm DuPont cable Header.

XICOOLEE Dual-CH ,Can Bus Expansion HAT for Raspberry Pi, with 2-Channel CAN Interface Communication, Dual Chips MCP2515 and ATA6561

Onboard SM24CANB (Transient Voltage Suppressor), anti-static and transient spike voltage
The module adopts dual chips of CAN controller MCP2515 and CAN transceiver ATA6561-GAQW-N. It supports dual-channel CAN interface communication, and only one module is needed to carry out CAN transceiver test on Raspberry Pi
Onboard level conversion circuit, the working level of 3.3V/5V can be switched by slide switch
Onboard 120Ω terminal resistance, it can be set Enable by slide switch
Leads out the SPI control interface, for connecting with host control boards like STM32/Ardui.Notice: The Raspberry Pi in photos is NOT included.

XICOOLEE Microwave Radar Sensor Module LD2410, 24GHz ISM Band, Human Presence Motion Sensing Module, Non-Contact Monitoring Detector, Horizontal Connect, with Bluetooth, Support GPIO and UART Output

1.It can sensitively sense static, micro moving, sitting and lying human bodies that cannot be identified by traditional solutions
2.It is plug and play and easy to assemble; Small and simple, the minimum size is only 7mmx35mm, and equipped with Bluetooth
3.The farthest sensing distance is up to 5 meters; Support ceiling, wall and otherinstallation methods
4.Accurately identify withinthe interval, supportthedivision ofthe sensing range, andshield the interferenceoutside the interval
5.Multi-level intelligent parameter adjustmentto meetthe needs of scene changes

XICOOLEE Motor and Servo Driver HAT for Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+/4B, Adopting Dual Chips PCA9685+TB6612, Drive Two DC Motors

This module can drive 2 channels of DC motors and 6 channels of servos at the same time.
Motor And Servo Driver HAT is an module of DC motor and servo driver specially designed for Raspberry Pi.
Onboard TB6612FNG, dual H-bridge motor driver, continuous driver current from each channel up to 1 A
Onboard PCA9685 chip, adopting I2C communication, built-in PWM driver and a clock, no need to continuously send signals to occupy the resources of the micro-controller.
It has designed a separate power switch. After power on, the POWER needs to be turned to the ON position. In addition, all the address lines of I2C are led out, and the address can be set by means of the DIP switch.

XICOOLEE RS485 to RJ45 Ethernet Module, Rail Guide RS485 Converter Module, Support Rail-Mount/Modbus Gateway

Standard guide rail design: suitable for internal installation of cabinet in industrial field.
Small size: relative to the ordinary serial port server, the width is small, does not take up much space.
Terminal type power supply, 9~24V wide voltage input, with anti-opposite power connection protection.
Terminal RS485 interface, support 32 slave devices. Baud rate support 300~115200bps. The data bit supports 5~9 bits, and the parity can be none Checksum, odd checksum, parity, markup, spaces these five ways.
Support TCP server side, TCP client, UDP mode, UDP multicast.

Xicoolee FAQs

We did a questionnaire online and hundreds of customers participated in this survey, the consumers rated the products in terms of quality, user experience and other aspects. The results of the questionnaire demonstrate how much customers appreciate their products. It's safe to say that most customers are overwhelmingly satisfied with their purchases and Xicoolee is worth your consideration.